VT2516A | VT2516A FPGA
Digital Module
The VT2516A module is connected to up to 16 mainly digitally used I/Os of an ECU, i.e. for signals with 2 states. In real vehicles for example, coding connectors, switches or signal lamps may be connected to these pins.
This module is also available as a variant (VT2516A FPGA) with user programmable FPGA.
Characteristics
Functions for Each Channel
- Various signal paths to the original sensor or the original actuator are switched via relays and are connected to a bus bar. The relays may be used, for example, to disconnect the line (broken wire simulation).
- Relay for short circuit between an input line and ground or battery voltage
- Relay for a connected external load, pull-up or pull-down resistor
- Sampling of a digital input value with configurable voltage threshold
- Determination of PWM signal parameters (frequency and duty cycle)
- Voltage measurement with calculation of instantaneous and average values
- Digital output with adjustable high and low levels
- Autonomous output of a bit stream loaded into module
- Generation of a PWM signal
Technical Data
| VT2516A | ||
| Input voltage | -40 V … +40 V | |
| Input current (via relays) | Max. 800 mA | |
| Input of digital signals | ||
| Threshold | 0 … 25 V | |
| Hysteresis | Approx. 1 V | |
| Sampling interval | 50 µs | |
| PMW frequency (PWM measurement) | 20 mHz … 200 kHz | |
| Voltage measurement | ||
| Accuracy (at 25 °C) | ± (0.5 % + 150 mV) | |
| A/D converter (per channel, internal) | 12 Bit / 1 kSamples/s | |
| Output of digital signal | ||
| High level, low level | 0 … 25 V | |
| Accuracy (at 25 °C) | ± (0.5 % + 200 mV) | |
| Slew rate (resistive load, 10 mA) | Typ. 20 V/µs | |
| Output current | Max. 30 mA | |
| Length of bit stream | 2 … 4,096 Bit | |
| Output of interval | 2 µs … 65 ms | |
| Frequency of generated PWM signal | 20 mHz … 25 kHz | |
| Basic Data | ||
| Supply voltage (via backplane) | 12 V ±10 % | |
| Power consumption (all relays off) | Typ. 8 W | |
| Power consumption (32 relays active) | Typ. 13 W | |
| Temperature range | 0 … 55 °C | |
| Dimensions (L x W x H) | 300 x 173 x 36 mm | |
| Weight | Approx. 540 g | |
| Maintenance | ||
| Calibration recommended | every 12 months | |
| Accredited (pre/re) calibration according to | ISO/IEC 17025:2017 | |
